Features |
- Ready-to-run Debian GNU/Linux
- 32-bit ARM Cortex-A8 600MHz
- 256MB DDR2 / 256MB NAND Flash
- 8" Panel, resistive Touch, sunlight readable
- Multiple Connectivity Interfaces
- 2 x LAN ports
- 2 x USB 2.0 Host and 1 x USB OTG
- 2 x RS232/422/485 / 1 x CAN-BUS
- 1 x Audio In/-Out
- 1 x SD-card slot bootable / 1 x CFAST-Slot
- 1 x mPCIe / SIM card slot for Wifi or 3G/4G-Modems
- Options: WLAN 802.11b/g/n / Bluetooth 2.1 EDR
- Low Power, fanless
- IP65 small size case
- Wall and VESA 75 mounting
|
Back to Top |
Specifications |
Software Specifications |
Linux |
Debian Lenny available as ready-to-run SD card image |
Back to Top |
System |
Hardware |
ARM Cortex-A8 32-bit RISC CPU, 600 MHz 256 MB SDRAM (512 MB option) 256 MB NAND Flash (512 MB option) Real time clock with battery backup (CR2032) Watchdog Timer
|
Mass Storage |
Internal NAND Flash Memory SD-card Reader SD 2.0 / SDHC CFast-Slot Type II, SATA connection
|
Network |
2x Fast Ethernet Option: WLAN 802.11b/g/n Option: Bluetooth 2.1 EDR
|
Display & Touch |
8" Panel 800×600 Resistive Touch function 1000 cd/m², outdoor sunlight readable
|
Audio |
Audio-In and -Out Jacks |
Expansion Slot |
1x miniPCI Express, USB 2.0 signals (for GSM/3.5G, GPS, …) SIM Slot for GSM/3.5G modems in miniPCIe slot
|
Serial Interfaces |
2x USB 2.0 as Host 1x USB 2.0 OTG 1x Console Port RS232, up to 115200 bps 2x RS232/422/485 up to 3.0 Mbps 1x CAN Bus up to 1.0 Mbps
|
LED |
1x Power on Front LAN: 2x 10M/Link, 100M/Link, integrated in RJ45 connector
|
Buttons |
1x Power On/Off 3x free for user application
|
Back to Top |
Display, Touch, Audio |
Display Size |
8 inch, in metal case |
Technology |
TFT-LCD Display |
Luminance |
1000 cd/m² |
Contrast ratio |
400 : 1 |
Resolution |
800 × 600 |
Aspect ratio |
4 : 3 |
Touchscreen |
Resistive Touch function |
Audio |
Analog Audio -In and -Out |
Back to Top |
Serial Ports |
No. of Ports/Type |
2 × RS232/422/485 selected by software or by DIP-switches Highspeed UART, 128 Byte FIFO |
Connector |
DB-9 male |
Operating Modes |
RS232 RS422 full duplex (120Ω on/off) RS485 4 wire, full duplex (120Ω on/off) RS485 2 wire, half duplex (120Ω on/off)
|
Configuration |
One DIP switch per port can set operating mode and RS422/485 termination Software can override the operating mode for each port No High/Low biasing resistors needed |
Signals |
RS232: TxD,RxD, RTS,CTS, DTR,DSR, DCD, RI, GND RS422: Tx+/-, Rx+/-, GND RS485 4 wire: Tx+/-, Rx+/-, GND RS485 2 wire: Data+/-, GND
|
RS485 Data Direction control |
by ARTc (Automatic Receive Transmit control) |
Data bits |
5, 6, 7, 8 |
Stop bits |
1, 2 |
Parity |
None, Even, Odd, Mark, Space |
Flow Control |
RTS/CTS, XON/XOFF |
Baudrate |
RS232: 200 bps to 921.6/1000 kbps RS422/485: 200 bps to 3.7Mbps Supports non-standard baudrates |
Back to Top |
CAN Bus |
No. of Ports/Type |
1 × CAN Bus |
Connector |
3-pin terminal block |
Signals |
CAN_H, CAN_L, CAN_GND |
Speed |
CAN 2.0A / 2.0B up to 1 Mbit/s |
Transceiver |
SN65HVD233 (Texas Instruments) |
Linux OS |
Supports SocketCAN and unified VSCAN API |
CANopen |
Open source CANfestival framework fully implements CANopen functionality. |
Back to Top |
Wireless interface (option) |
Standards |
2.4GHz Radio, supports IEEE Std. 802.11b/g/n |
WLAN Modes |
Access Point (AP) or Client (Station) |
TX Power |
- 802.11b:
- Typ. 15.5dBm ±1.5 dBm @ 1Mbps (DSSS)
- Typ. 15.5dBm ±1.5 dBm @ 11Mbps (OFDM)
- 802.11g:
- Typ. 15.6dBm ±1.5 dBm @ 6Mbps (CCK)
- Typ. 13.5dBm ±1.5 dBm @ 54Mbps (OFDM)
- 802.11n:
- Typ. 13.4dBm ±1.5 dBm @ 6.5Mbps (OFDM)
- Typ. 13.3dBm ±1.5 dBm @ 150 Mbps(OFDM)
|
RX Sensitivity |
- 802.11b:
- -95.6dBm @ 1Mbps, -88dBm @ 11Mbps
- 802.11g:
- -91.3dBm @ 6Mbps, -74.2dBm @ 54 Mbps
- 802.11n:
- -88.8dBm @ 6.5Mbps (20 MHz), -72dBm @ 72.2Mbps (20 MHz)
|
Transmission Rate |
802.11b: 11Mbps 802.11g: 6 to 54Mbps 802.11n: 6.5 to 150Mbps |
Transmission Distance |
Up to 100m in open areas |
Wireless security |
WEP WPA WPA2 WPA2-Enterprise (IEEE 802.1X/RADIUS)
|
Antenna Connector |
RP (Reverse-Polarity) SMA |
Bluetooth |
Bluetooth 2.1 EDR |
BT Antenna |
shares antenna with WLAN function |
Back to Top |
Power Requirements |
Input Voltage |
9 — 30V DC |
Power Consumption |
0.9A @ 12V minimal 1.8A @ 12V typical, plus devices on USB
|
Connector |
2-pin Terminal Block |
Back to Top |
Housing and Mounting |
Case |
0.8mm sheet metal |
Weight |
w/o box 1.40kg; w/h box 1.85kg |
Dimensions |
219×44×179 mm³ (W×L×H) |
Mounting |
Panel Wall Mount VESA 75×75
|
Back to Top |
Environmental Data |
Operating Temp |
−10°C — 50°C |
Storage Temp |
−20°C — 70°C |
Ambient Humidity |
10-85% non-condensing |
Back to Top |
Standards |
Certifications |
CE, FCC |
EMI |
EN 55022 Class B EN 61000-3-2: Limits of harmonic current emissions EN 61000-3-3: Limitation of voltage changes 47 CFR FCC Part 15 Subpart B
|
EMS (EN 55024) |
EN 61000-4-3: Radiated RFI EN 61000-4-4: Electrical Fast Transient EN 61000-4-5: Surge EN 61000-4-6: Induced RFI EN 61000-4-8: Power Frequency Magnetic Field EN 61000-4-11: Power supply dips
|
ESD |
EN 61000-4-2 4kV contact 8kV air for USB and Ethernet |
Back to Top |
MTBF (Mean Time Between Failures) |
MTBF |
soon available |
Standard |
Telcordia (Bellcore) Standard; RelCalc. 5.0 BELL-7 |
Back to Top |
Warranty |
Warranty Period |
2 years |
Back to Top |
Open Source Software |
Licenses |
This product uses open source software to fulfill part of its functions. Licenses for the open source software are granted under the GNU General Public License in various versions. For details about those see the information in the firmware download and visionsystems.de/opensource |
Back to Top |
Ordering Information |
6850 |
VS-860 |
|
VS-860 WLAN (with Bluetooth and Wireless LAN) |
Back to Top |
Options |
6031 |
Power adapter 110-230V AC to 12V @1A, DC, EU plug |
6034 |
Power adapter 110-230V AC to 12V @1A, DC, US plug |
6855 |
Starter Kit Linux 4GB microSD card for Linux inserted Power adapter 12V @ 1A Adapter cable for console port Documentation and Development Software on DVD
|
3314 |
GSM/UMTS mPCIe card for 3G modem |
3316 |
4G-Modem LTE for mPCIe incl. IPEX cable & SMA Antenna |
Back to Top |
Packaging |
Packing list |
VS-860 RISC Panel PC 2-pin Terminal Block for power supply 3-pin Terminal Block for CAN Bus 4 × hooks for Panel Mount Antenna (WLAN model only)
|
Back to Top |